If you are already setup for the TB3 on a Stage 1 or 0 the short answer is yes. If you have one of the motors purchased from us with swappable cables (the cable detaches on the motor port) then you can order up a spectrum motor cable for your AUX motor on the DP slider and spectrum. This can be ordered here: http://store.emotimo.com/spectrum-stepper-motor-cables-p112.aspx
We recommend a reliable ball head to level incline shots and this also comes in handy for additional clearance on the DP Stage 1 dolly as spectrum rotates much lower than the TB3 and the aux stepper motor interferes with spectrum's full range of motion.
If you have a motor from DP, their pin outs are slightly different on the motor side. If you are a DIY'er and are comfortable swapping pins on the spectrum cable you can make it work with DP motors.
Top down and from left to right the spectrum works with color layout black, green, red, blue.
BLACK GREEN RED BLUE for eMotimo motors
To make this cable work with Dynamic Perception motors, you will need to switch the second and 3rd wire: BLACK RED GREEN BLUE for Dynamic Perceptions motors
you will have a modified cable that can now only drive DP motors. This modification voids warranty on the cable though as you can break the connector's plastic housing or metal pins so be careful!
If you aren't a DIY'er we will have a cable in our shop that we have modified for this purpose shortly.
The obvious benefit of this cable is that it will now work with your DP motors, but it does have its disadvantages. The eMotimo spectrum has been developed for eMotimo motors. Our high torque modes and high speed modes (turbo) work specifically for the motors we offer and develop for. When using the spectrum with 3rd party motors, we cannot guarantee our specs any longer. Please do not expect DP motors to run as fast or have the same torque promised with eMotimo stepper motors.
We do not offer support for DIY cables and 3rd party motors we have not tested against.